WaveWarp 2.0 Component
      
Output ASCII Files:
Output Control ASCII file
|
Functional Description
Represents an ASCII file as a control signal output destination.
The Output ASCII Files category of the Component Library includes the filenames of
all files with the ".txt" extension located in the user-specified directory on the hard-disk.
For notational convenience, all such files are listed three times each, reflecting their intended use, i.e.
as a mono audio file, a stereo audio file, or as a control signal file.
The control signal entry for a given file in the list can be used as a control signal output
component on the DrawingBoard. Only one instance of the same file can be
connected up on the DrawingBoard.
All connected output files are over-written when the DrawingBoard is
played so they should be used with caution. For convenience, and to avoid unintentional over-writing, a set of
"place-holder" template output files are always available (regardless of the user-specified directory).
These template files are listed in the following table:
| Filename | Description |
|---|
| NewMono.txt | Empty ASCII file intended for mono audio data |
| NewStereo.txt | Empty ASCII file intended for stereo audio data |
| NewControl.txt | Empty ASCII file intended for control signal data |
These files can be used on the DrawingBoard as if they were standard (i.e. non-empty) ASCII files. When data
has been written to any such file (i.e. after playing the DrawingBoard), it is advisable to change its
name so as to preserve the recorded data as well as to preserve the "place-holder" name for
new files. The name of any file on the DrawingBoard can be changed by double-clicking on its filename.
This will open a conventional "Save As" file dialog box which can then be used to rename the file in the usual
"Windows" manner.
When the DrawingBoard is played, the 32-bit floating point data sent to each ASCII file is
written "as is", one sample value per line.
The file is written at the sample rate of the upstream component. However, since the ASCII file does not
store the value of the sample rate, it is irrelevant once the file is written. All that remains is a list
of floating-point sample values, one per line.
CAUTION: WaveWarp does not scan for the end of ASCII files. Therefore, if a DrawingBoard contains
only ASCII files (i.e. no WAV files), it will continue playing forever. It is particularly important
to bear this in mind whenever Output ASCII files are used. If left alone, the DrawingBoard will
continue writing to the file(s) indefinitely, rapidly filling up the hard-disk! It is the user's
responsibility to manually issue the Stop command (via the Transport Window or toolbar) at the desired
point in time.
Note: ASCII files are useful when prototyping a DrawingBoard or when investigating the detailed
behaviour of a component or set of components. Since the ASCII data is read "as is" without any scaling (unlike
with WAV files) the precise behaviour of a component or set of components can be ascertained from the detailed
comparison of input and output ASCII files. However, since the ASCII representation is intrinsically
inefficient, ASCII files should only be used with small "test" files, and should not be used for the
storage of material of any significant length.
Note for
MATLAB®
users:
since it is trivial to import and export ASCII files from within MATLAB (i.e.
using the "-ascii" switch with the "load" and "save" commands), it is straightforward to read ASCII files
produced by WaveWarp for off-line processing, or indeed, to create ASCII input test files for use by WaveWarp.
Algorithm
n/a
Signal Implementations
| Audio signals | Control signals | Description |
|---|
| n/a | Single input | Sends a control signal to an ASCII file as a list of numbers |
Related components:
Example DrawingBoards illustrating usage:
|
